![]() This leads me to believe it is an issue with the NVR but I can't figure out what or why. An NVR reboot does not fix the issue, but turning off a couple of the cameras does. Is it possible to set the screen location via some user setting to force the Reolink Client application to start in a specific location For whatever reason, the reolink client does not 'remember' the last position when it's closed in Windows 11. When I Stream the cameras from the NVR On "Fluent" or "Balanced" usually works ok however once on "3840*2160" or "5MP" (for the lower quality cams) the issues start. This is unacceptable performance as it should be 24/7 continuous, uninterrupted recording as advertised. The issue is also when trying to play back clips in high format. This also affects the recordings as I have went back and tried to view recordings and some skip time. My cameras do not show up on the firmware page. It actually worked this morning, and I can access the recordings on the Reolink website. Bought the cameras a week ago, and the cloud has worked on the app until this afternoon. Streams stop, time stops ticking, feed goes green. Recorded videos won’t load in the cloud tab in the app. If the clear stream failed on either phone App or computer client, check whether other devices are viewing the same camera in clear mode at the same time. If clear stream can work via Client, please disable 'hardware decoding' on Android App and check it again. Even after disconnecting the Reolink Client device, the streams appear degraded by watching the NVR directly (HDMI) for an extended duration of time. Most of the time, the Reolink client is not finding a camera in the network the problem is related to a wrong network configuration or a firewall blocking the traffic between the devices. If the clear stream failed on App, try on computer client. Make sure the subject is within the illumination range. Change the Installation Environment (Applies to all above functions) Avoid IR reflection. The bitrate shown in the Reolink Client will change from about 8192 down into the 2000s and sometimes to 0 during a complete freeze of the stream. Refer to: Set Up the Record Encode for Reolink Cameras. However the issues start when streaming any camera feed from the NVR. Is it possible to set the screen location via some user setting to force the Reolink Client application to start in a specific location For whatever reason, the reolink client does not 'remember' the last position when its closed in Windows 11. (2) E1 ZOOM IPC_515SD6 V3.0.0.716_21112408Īdding each individual camera to to Reolink APP the streams are fine even in max. ġ - RLN16-410 16 Port 4K NVR Connected to Unifi POE switchĭevice models with firmware listed below:Īll latest versions of (Reolink Client Windows 10, Android, iOS) and Camera and NVR firmware as of today 1/1/22 Having same issues as described in this thread. ![]()
0 Comments
Leave a Reply. |